Husqvarna K 770 Vac, Руководство оператора

Страница: 19 / 104

1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill fuel
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
It causes damage to the product.
CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). It
causes damage to the product.
Note: Carburetor adjustment is in some conditions
necessary when you change the type of fuel.
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let the remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To start the product with a cold
engine
WARNING: Make sure that the cutting blade
can rotate freely. It starts to rotate when the
engine starts.
1. Make sure that the STOP switch is in the left
position.
2. Pull the choke control fully and get the start throttle
position.
705 - 002 - 12.11.2018 19