Husqvarna F2201V1, Руководство пользователя

Страница: 51 / 158

TUNING THE CHASSIS 10
49
Info
Turn clockwise to increase the damping; turn
counterclockwise to reduce damping when the shock
absorber rebounds.
10.16 Handlebar position
H01188-10
The holes on the handlebar supports are placed at a distance
of
A
from the center.
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
10.17 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
Preparatory work
–
Remove the handlebar cushion.
H01189-10
Main work
–
Remove screws
1
. Take off the handlebar clamp. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports
3
.
–
Position rubber bushings
4
and push through nuts
5
from
below.
–
Place handlebar supports in required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
2
.
Guideline
Screw, handle-
bar support M10 40 Nm (29.5 lbf ft)
Loctite
®
243™
–
Position the handlebar.