Husqvarna F1303V1, Руководство пользователя

Страница: 36 / 140

7 COMBINATION INSTRUMENT
34
7.17 Setting the clock
Info
The clock is displayed in 24-hour format.
The time must be reset if the 12-V battery was disconnected from the vehicle or the fuse was removed.
Condition
The motorcycle is stationary.
F01410-10
–
Press the MODE button briefly and repeatedly until ODO
appears on the display.
–
Press the MODE button and SET button simultaneously for
five seconds.
The time display begins to flash.
Info
The clock can be set in the ODO display for each
menu by keeping the MODE button and SET button
pressed simultaneously.
–
Set the hours display using the MODE button.
–
Set the minutes display using the SET button.
–
Press the MODE button and SET button simultaneously.
The set time is adopted and saved.
7.18 Adjusting the shift speed RPM1
Condition
The motorcycle is stationary.
ODO > 1,000 km (621 mi).
F01400-01
–
Press the MODE button briefly and repeatedly until TRIP 1
appears on the display.
–
Press the
MODE
button for 5 seconds.
The
RPM1
display appears.
Info
The RPM1 display appears in the TRIP 1 display for
each menu by keeping the
MODE
button pressed.
RPM1
is the engine speed above which the shift
warning light starts flashing.
The engine speed can be set at intervals of 50.
The shift speed
RPM1 can only be set up to maximum
50 rpm below the shift speed
RPM2
.
–
Set the speed with the MODE button and SET button.
Info
The MODE button increases the value.
The
SET
button decreases the value.
–
Press the MODE button and SET button simultaneously.
The RPM1 display disappears and the set shift speed
RPM1 is adopted and saved.