Husqvarna DURATIQ XP6, Руководство оператора

Страница: 13 / 116

Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To remove the product from the
package
WARNING: Move the product from the pallet
carefully and safely. The product is heavy
and can cause serious injury if it falls.
• Make sure that all items that is shown in the product
overview, are included. Refer to
Product overview,
right side on page 3
. Speak to your Husqvarna
dealer if an item is missing or damaged before you
move the product from the pallet.
• Remove all package straps and wheel chocks.
• Make sure that the area is clear and that you have
sufficient space to move the product.
• Make sure that there is no risk that you or the
product can fall.
• Use lifting equipment or ramps to move the product
from the pallet. The product is heavy. Move the
product safely. Refer to
To lift the product on page
34 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Put on necessary personal protective equipment.
Refer to
Personal protective equipment on page 10
.
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
Maintenance
schedule on page 24 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to Work area
safety on page 10
.
7. Make sure that there are diamond tools on the tool
plates and that the diamond tools and tool plates are
tightly attached.
8. Connect a dust extractor to the product. Refer to To
connect a dust extractor on page 15
.
9. Adjust the handle and the handlebar to an applicable
operation height. Refer to
To adjust the handle and
the handlebar on page 16 .
10. Make sure that the battery is connected. Refer to
To
connect the battery on page 18 .
11. Make sure that the propane tank is connected. Refer
to
To connect and disconnect the propane tank on
page 18 .
12. Fill the tank with cold water. Refer to
To fill the water
tank with water on page 26 .
13. For wet grinding, connect a water hose to the
product. Refer to
To connect the product to a water
hose on page 18 .
14. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
Disc holder alternatives for diamond tools
• Use a Redi lock disc holder to attach metal bonded
diamond tools.
• Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has an
effect on the end quality of the surface. The
configuration also has an effect on the operation rate of
the product.
1268 - 002 - 25.05.2020 13