Husqvarna DE 110i, Руководство оператора, Страница: 24 / 104

Error codes
Error
code
Error Description Probable cause(s) Action(s)
2
HEPA filter miss-
ing.
Product shuts down/does not
start.
+ Warning light on HMI.
+ HEPA symbol on HMI.
HEPA filter is missing or dam-
aged.
Assemble or replace
the HEPA filter.
3
Low supply volt-
age.
Low performance (low air flow/
vacuum).
Too low voltage in grid/power
supply.
Make sure correct
grid/power supply is
used.
4
High supply volt-
age.
Product shuts down/does not
start.
+ Warning diode light on HMI.
Too high voltage in grid/power
supply.
Make sure correct
grid/power supply is
used.
Wrong battery used. Use correct battery.
5
Main Pressure
Sensor Error.
Prefilter light flashes red.
Vacuum hose is disconnected
or blocked.
Speak to an ap-
proved service agent.
Control unit is damaged.
6
PCBA tempera-
ture too high.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Too high ambient temperature.
Do not use the prod-
uct outside specified
temperature range.
7 Fan malfunction.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Fan is damaged or disconnec-
ted.
Speak to an ap-
proved service agent.
Control unit is damaged.
9
One wire com-
munication not
detected.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Cable disconnected or dam-
aged.
Speak to an ap-
proved service agent.
Transportation, storage and disposal
To move the product short distances
Make sure that the intake valve is closed. Make sure
that the dust caps are on the hoses.
1. Put the product down on the ground. (Fig. 48)
2. Lift the product manually. (Fig. 49)
3. If 2 persons lift the product, make sure to use the 2
lifting points. (Fig. 50)
To move the product long distances
Make sure to use a closed vehicle during transportation
of the product.
Make sure that the intake valve is closed. Make sure
that the dust caps are on the hoses.
1. Make sure that the Longopac is installed on the
product.
2. Make sure that the Longopac bag is empty.
3. Attach the power cord, the dust extraction hose and
the handle pipe tightly to the product. (Fig. 51)
4. Lock the transport wheels. (Fig. 21)
5. Lift the product, refer to
To lift the product on page
25 .
24 1618 - 004 - 24.01.2022