Husqvarna BG Combi, Руководство оператора

Страница: 10 / 24

Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
Maintenance Before use,
each 10 h
After the first
20 h
Yearly, each
500 h
Make sure that there are no oil leaks. *
Clean the product. X
Make sure that nuts and screws are tightened. *
Lubricate the blade shafts after the product is cleaned. X X
Make sure that the controls can move smoothly. *
Examine the wires for damage and make sure that they are cor-
rectly adjusted.
*
Clean the blade shaft. X
Clean the pressure plate. X
To clean the product
CAUTION: Do not use a high-pressure
washer to clean the product.
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
• Use running water from a hose to clean the product.
CAUTION: Do not point the water
directly at the electrical box for the quick
stop or the motor.
• Remove grease and oil from the handle.
To set the product in maintenance
position
WARNING: Disconnect the power cord from
the power source to prevent accidental start.
The maintenance position is used for all maintenance
procedures in the blade area below the product.
• Tilt the product rearward until it is stable on the
handle and the transport wheels.
10 1124 - 001 - 06.04.2020