MAINTENANCE
English
–
21
1157433-49 Rev. 2 2015-10-20
Angle gear
The angle gear is filled with a sufficient quantity of grease
at the factory. However, before using the machine you
should check that the angle gear is filled to 3/4 with
grease. Use HUSQVARNA special grease.
The grease in the bevel gear does not normally need to
be changed except if repairs are carried out.
Adjusting the edger’s cutting
depth
The cutting depth must be adjusted before starting work.
•
Loosen the handle nut.
•
Loosen the wing nut.
•
Set the desired cutting depth.
•
Tighten the screw.
CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.
