Husqvarna 525DEPS, Руководство оператора

Страница: 18 / 100

Automatic shutdown function
The product is equipped with a shutdown
function that deactivates the product if it is not
used.
To stop the product
1. Release the power trigger or the power
trigger lockout.
2. Push the stop button.
3. Push the release buttons on the battery
and pull the battery out.
To use the correct chain oil
WARNING:
Do not use waste
oil, which can cause injury to you
and the environment. Waste oil also
causes damage to the oil pump, the
guide bar and the saw chain.
WARNING:
The saw chain can
break if the lubrication of the cutting
equipment is not sufficient. Risk
of serious injury or death to the
operator.
WARNING:
Use the correct
chain oil for this function to operate
correctly. Speak to your servicing
dealer when you select your chain
oil.
Note:
This product has an automatic chain
lubrication system. You can also adjust the oil
flow. Refer to
To adjust the chain lubrication
on page 26.
• Use only Husqvarna dielectric chain oil.
CAUTION:
In temperatures
below 0°C/32°F some chain oils
become too thick, which can
cause damage to the oil pump
components.
• Use the recommended cutting equipment.
Refer to
Recommended cutting equipment
on page 30.
To use the product
• Hold the product as close to your body
as possible to get the best balance. Use
the harness to support the weight of the
machine and make it easier to handle.
• Make sure that the tip does not touch the
ground.
• Do not rush the work, but work steadily
until all the branches have been cut back
cleanly.
• Always work at full throttle.
• Whenever possible position yourself so
that you can make the cut at right angles to
the branch.
• Do not work with the shaft held straight
out in front of you as this increases the
apparent weight of the cutting attachment.
18 1824 - 003 - 28.06.2022