Husqvarna 333R, Руководство по ремонту

Страница: 7 / 62

5
1
Starter
Assembly
Clean the component parts and
assemble in the reverse order as set out
for dismantling.
Assembly
Clean component parts before
assembling.
Replace the return spring/starter pulley
and starter cord, if necessary.
Lubricate the spindle with a little grease
and fit the starter pulley.
Position the washer and tighten the
screw.
Assemble a new starter cord. Slide it
into the starter pulley’s slot as
illustrated and then out through the
cord guide in the starter housing.
Make sure that the knot at the end of
the cord is as small as possible and
that it is pressed in the starter pulley!
NOTE!
The return spring and starter pulley
are supplied pre-assembled and
are fitted in the starter housing as
a single unit.
Exercise care when opening the
packaging so that the spring does
not fly out.
Assemble the starter pulley.
Assemble a new starter cord.
NOTE!
A new starter cord can be fitted
without the need of dismantling
the starter!
Assemble the starter handle. Assemble the starter handle.
Tie a double knot and fold under the
free end.
Pull the knot fully into the handle.
Tension the return spring.
Check the spring tension.
Tension the return spring.
Pull out the starter cord completely and
slow the starter pulley with your thumb.
Lift the starter cord up out of the cut-out
on the starter pulley.
Now turn the starter pulley anticlock-
wise, 6 turns.
Check the spring tension. With the
starter cord fully extended it should still
be possible to turn the starter pulley
further,
at least a half turn.