Husqvarna 115H, Руководство оператора

Страница: 22 / 52

a) Push the arrow buttons to select
Current day to only set the current day
to factory settings.
b) Push the arrow buttons to select All
week to reset all schedule settings to
factory settings.
3. Push the OK button.
3.10.3 Security level
There are 3 security levels for the product.
Function Low Medium High
Alarm X
PIN-code X X
Time lock X X X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.3.1 To set the security level
Select 1 of 3 security levels for your product.
1. Do steps 1–3 in
To get access to the menu
on page 20.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Security > Security level.
3. Use the arrow buttons and the OK button
to select the level of security.
4. Push the OK button.
3.10.3.2 To change the PIN-code
1. Do steps 1–3 in
To get access to the menu
on page 20.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Security > Advanced > Change PIN-code.
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3.
3.10.4 Lawn Coverage
The Lawn Coverage function is used to guide the
product to remote parts of the work area.
You can divide your lawn into 3 areas.
3.10.4.1 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 20.
2. Use the arrow buttons and the OK button
to move through the menu structure Settings
> Lawn Coverage > Area 1-3.
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the start of the area. Measure
along the guide wire. Refer to To measure
the distance from the charging station on
page 23.
6. Push the arrow buttons to select the
distance, measured in m.
7. Push the OK button.
8. Use the arrow buttons to select the % of
the cutting time the product must cut the
area. The % is equal to the % of the area in
relation to the complete work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
22 - Installation 982 - 001 - 12.12.2018