HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 51 / 285

04/SHOCK ABSORBER, SWINGARM
49
200269-10
–
As soon as the pressure gauge has attained the specified value, turn the Damper

control lever to Vacuum .
Guideline
3 bar
The pressure gauge drops to the specified value.
0 bar
–
As soon as the pressure gauge has attained the specified value hat, turn off the
On/Off
switch.
Guideline
0 bar
The vacuum pump has been switched off.
200783-10
–
Slide O-ring

to the end of the special tool by the specified value (distance

minus specification).
Guideline
10 mm
Depth micrometer (T107S) ( p. 274)
–
Push the floating piston into the reservoir using the special tool up to the reduced
dimension.
Info
The floating piston must be set precisely to this position with the piston rod
fully extended, as otherwise damage could occur when the shock absorber is
compressed.
–
Remove the special tool.
200784-10
–
Remove adapter

from connection

of the vacuum pump.
Info
Hold the shock absorber in such a way that the filling port is positioned at
the highest point.
–
Remove the adapter.
–
Mount and tighten screw

.
Guideline
Filling port screw M10x1 14 Nm
(10.3 lbf ft)
7.26
Filling the shock absorber with nitrogen
200814-10
–
Screw in the screw

approx. two turns, but do not tighten.
Info
The piston rod is completely extended.
200815-10
–
Keep the special tool in place in the bench vise.
Nitrogen filling tool (T170S1) ( p. 277)
–
Connect the special tool to the pressure regulator of the filling cylinder.
Filling gas - nitrogen
–
Adjust the pressure regulator.
Guideline
Gas pressure 10 bar (145 psi)