HUSABERG 2013 TE 125 EU, Руководство пользователя

Страница: 50 / 129

11 SERVICE WORK ON THE CHASSIS
48
602534-10
–
Remove O-ring
3
. Remove protective ring
4
.
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
11.12 Installing the lower triple clamp
x
0 0 2 2
0 0 1 1
0 0 3 3
500098-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease ( p. 121)
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
1
is correctly positioned.
–
Slide on protective ring
2
and O-ring
3
.
602535-10
–
Position the upper triple clamp with the steering.
–
Mount screw
4
but do not tighten yet.
–
Mount the clutch line with cable guide
5
.
602536-10
–
Position the fork legs.
Info
The rebound damping is located in the right fork leg (red adjusting screw).
The compression damping is located in the left fork leg (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
6
toward the front.
602540-10
–
Tighten screws
7
.
Guideline
Screw, bottom triple clamp M8 12 Nm (8.9 lbf ft)