Inst339 Filtrite Salt Chlorinator V09.20
10
GENERAL OPERATION / POOL CHEMISTRY
Setting the right chlorine output and filtration time
Your Filtrite chlorinator must be run every day to ensure that your pool is correctly sanitised. As the sun dissipates chlorine,
running times are higher in the summer compared to the winter. It is recommend that you initially run you chlorinator at
maximum output
Summer Operation
You should set your chlorinator to operate for 8 to 10 hours per day. Ideally, run it for 4-5 hours in the morning (say 8-
12pm) and 4-5 hours in the evening (say 6.00-11pm).
In extremely hot weather it may be necessary to extend the running time if you find that the free chlorine level is too low.
Winter Operation
You should set your chlorinator to operate for 6 to 8 hours per day. Again, running it in the morning and evening is
preferable.
Checking Chlorine Level
Ideally, check you chlorine level after the morning operating period. The free chlorine residual level should be somewhere
between 1 and 3 part per million. Increase or decrease the output of the chlorinator to get the right residual chlorine level.
It may also be necessary to adjust the operating period if you are running at minimum or maximum output. Note: During
extreme temperature periods, it may be necessary to provide additional chlorine to assist your salt chlorinator. Always
use Filtrite Stabilised Dichlor Pool Chlorine when supplementing chlorine in your pool.
Stabiliser
As previously mentioned, sunlight rapidly dissipates the amount of free chlorine in your pool. Chlorine stabiliser (also known
as Cyanuric Acid or Sunscreen) greatly reduces this effect.
Without stabiliser, you may need to run your chlorinator and filtration system up to 16 hours per day or longer!!!
Keep the Stabiliser reading between 30 and 60ppm.
pH Level
You should keep you pH level between 7.0 and 7.4 for fibreglass pools and 7.2 to 7.6 for other pools.
Total Alkalinity
The ideal range is between 80 and 120 ppm.
Salt Level
Although salt is not consumed by the chlorinator, salt is lost during backwashing, and when your pool overflows due to rain
or splashing. The correct salt level is important to cell life and the effective operation of your chlorinator. Salt level should
be maintained around 4,000ppm but should never be allowed to fall below 3,000ppm.
A typical pool of around 50,000 litres requires 200kg of salt to initially set-up the pool to 4,000ppm.
A low salt level warning is indicated on your Filtrite chlorinator if the salt level drops. If Low Salt is indicated, check again in
24 hours and then if it is still indicated, add two 25kg bags of salt to the shallow end of your pool. Run the filtration system
for approx. 6 hours to help mix the salt in the pool. It can take up to a day for the salt to fully dissolve.
If the low salt light is still on, then you should get your pool water tested. If the salt level is above 4000ppm then you may
need to have your chlorinator checked.
Warning: Some people recommend that you put salt directly in the skimmer box. This is a very bad practice as it allows very
high concentrations of salt to be passed through your filtration and other pool equipment. Adding salt in this fashion may
void warranty on some manufacturers products.
