Hurco winmax, Руководство по программированию

Страница: 36 / 254

1 - 16 Overview
704-0115-307
WinMax Lathe NC Programming
Program Review
Press the Review console key to display the NC Subprogram Review screen. A summary
of the NC subroutines appears by number.
Figure 1–4. NC Subprogram Review screen
To go directly to a subroutine, place the cursor on it, and press the Enter key or the JUMP
TO SUBPROGRAM F3 softkey. Refer to NC Editor Menus, on page 1 - 17 for information
about the NC Editor’s screen and softkeys.
These Standard Console keys perform these functions with the Program Review screen:
• The Home console key jumps to the first subroutine listed in the Program
Review screen.
• The End console key jumps to the last subroutine listed in the Program
Review screen.
• The Page Up console key jumps to the first subroutine visible on the screen.
• The Page Down console key jumps to the last subroutine visible on the
screen.
You can clear, delete, copy, and move data blocks to another location in a part program or
even another program using the Edit Functions described in the Edit Functions Menu, on
page 1 - 21.
When the entire part program contains more subroutines than can
be displayed on one screen, use the Page Down and Page Up
console keys or the scroll bar located on the right-hand side of the
screen to scroll through the listed subroutines.
To select multiple blocks, select the first block and move the pointing
device down to the last block without lifting the stylus.
With the optional AT-keyboard, you can use Ctrl + select (using the
pointing device for selecting) to select non-consecutive data blocks.