Hurco winmax, Руководство по программированию

Страница: 233 / 254

WinMax Lathe NC Programming
704-0115-307
ISNC M Codes
5-25
Chuck Air On (ISNC M16)
M16 turns on the chuck air blow.
Chuck Air Off (ISNC M17)
M17 turns off the chuck air blow.
Set Max Rapid (ISNC M94)
M94 is used to set the maximum rapid rate for the program. M94 requires an argument to
specify the maximum rapid rate and must be expressed as MMPM.
M94 Example:
M94:5080
This block sets the Maximum Rapid Rate to 5080 MMPM (200 IPM).
Part Transfer Sub-spindle (ISNC 241)
M241 allows the sub-spindle chuck to open while the sub-spindle is running. This
interlock bypass is cancelled auto0matically when M115 (Close Sub-spindle Chuck) is
executed.
End of Program (no rewind) (ISNC M2)
M2 stops program execution and leaves the part program pointer on the block that
follows the M2 command. M2 is required at the end of all programs. It commands the
spindle to turn off. Execute at the end of the block after all motion occurs.
Steady Rest Clamp (ISNC M38)
The Steady Rest device can be manually hitched to the Z-Axis to assist with movement of
the Steady Rest to the proper location. The position of the Steady Rest device is tracked
in order to avoid colliding with the tailstock.
A safety switch located on a bracket under the way cover also protects against the Steady
Rest and Tailstock colliding. If the safety switch is tripped, the machine will enter the
Emergency Stop mode.
This optional device is used with turning centers to hold long pieces of stock in the center
while cutting.
The position of the Steady Rest can only be tracked when moving the
Steady Rest with the Z-Axis. If the Steady Rest is moved manually
without the use of the Z-Axis, then the control will not be aware of
this new position for the Steady Rest which will either allow the
tailstock to possibly collide with it or improperly limit the motion of
the Z-Axis when hitched to the Tailstock.