Hurco AB6, Руководство по установке

Страница: 84 / 165

Installation
Autobend 6 November, 1999 2-45
Gauge Bars
The Autobend utilizes three types of gauge bars: the Y-Shaped Rigid
Gauge Bar, the Tilting Gauge Bar, and the LP11, LP21, and LP22 Gauge
Bar. Following are instructions for installing each type.
Y-Shaped Rigid Gauge Bar
The Y-Shaped Rigid Gauge Bar is installed on Autobend’s S6, S7, and S8
gauges. Vertical supports hold it to the gauge. This type of gauge bar
provides an accurate positive stop for the material being bent. Flip fingers
installed on the gauge bar provide clearance for the material as it is bent.
To install the Y-Shaped Rigid Gauge Bar, follow these instructions:
1. Loosen the socket head cap screws of the upper and lower
clamp bars located on the vertical supports (see the figure
below).
Figure 2-35. Position of Gauge Bar and Vertical Supports
2. Insert compression springs into the cavities of both the lower
and upper clamp bars. See the figure on the following page.
3. Install the lower clamp bars with just a few turns of the
screws.
4. Position the Y-shaped gauge bar into the lower clamp bars
and tighten slightly.
5. Install the upper clamp bars and compression springs,
tightening slightly.
6. Using a level, check the gauge surface and make any
necessary adjustments to position the gauge bar both
vertically and horizontally.
7. Tighten the upper and lower clamp bars securely.