Hurco AB6, Руководство по установке

Страница: 156 / 165

Installation
Autobend 6 November, 1999 2-117
AB6 Installation Checklist
While installing the AB6, check each item below as it is completed:
❑
1. Read all safety related information.
❑
2. Disconnect the power to the press brake.
❑
3. Locate an area on the press brake for mounting the AB6 power
cabinet and console. Note cable (harness) lengths when these
components are not mounted on the same side.
❑
4. Mount the AB6 power cabinet.
❑
5. Mount the AB6 console either directly to the press brake or with the
optional pendant arm bracket.
❑
6. Mount the console to the pendant arm.
❑
7. Locate a position to mount the gauge(s) that will allow the gauge bar
to be positioned to the same height as the work.
❑
8. Mount the gauge(s).
❑
9. Mount the vertical supports.
❑
10. Mount the gauge bar.
❑
11. Install the advance switch or relay.
❑
12. Connect the advance wires to the advance switch (or press brake
circuit). Connect the advance wires to the advance relay on hydraulic
press brakes.
❑
13. Connect the advance wires to the AB6 power cabinet at the main
board connector J8. (Install advance relay on hydraulic press brakes.)
❑
14. Install the optional retract switch (if using that option).
❑
15. Connect the retract wire to the AB6 power cabinet at the main board
connector J8.