Huntleigh DA100PB, Руководство по обслуживанию, Страница: 7 / 73

General
771402-2 dopplex ABIlity Service Manual
7
2.8 Electromagnetic Compatibility
Make sure the environment in which dopplex Ability is installed is not subject to strong sources of
electromagnetic interference (e.g. radio transmitters, mobile phones).
This equipment generates and uses radio frequency energy. If not installed and used properly, in strict
accordance with the manufacturer’s instructions, it may cause or be subject to interference. Type-tested
in a fully configured system, complies with EN60601-1-2, the standard intended to provide reasonable
protection against such interference. Whether the equipment causes interference may be determined by
turning the equipment off and on. If it does cause or is affected by interference, one or more of the
following measures may correct the interference:

Reorienting the equipment

Relocating the equipment with respect to the source of interference

Moving the equipment away from the device with which it is interfering

Plugging the equipment into a different outlet so that the devices are on different branch circuits
WARNING: The use of accessories, transducers and cables other than those specified, with the
exception of transducers and cables sold by the manufacturer of the dopplex Ability as replacement
parts for internal components, may result in increased emissions or decreased immunity of the
dopplex Ability.
WARNING: The dopplex Ability should not be used adjacent to or stacked with other equipment and
that if adjacent or stacked use is necessary, the dopplex Ability should be observed to verify normal
operation in the configuration in which it will be used.
Guidance and Manufacturer’s declaration - electromagnetic emissions
The dopplex Ability is intended for use in the electromagnetic environment specified below. The customer or the user of the dopplex Ability
should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment - guidance
RF emissions
CISPR 11
Group 1
The dopplex Ability uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
The dopplex Ability is suitable for use in all establishments, including domestic establishments
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Voltage fluctuations /
flicker emissions
IEC 61000-3-2
Class A
Harmonic emissions
IEC 61000-3-3
Complies