Huntleigh AlphaBed, Руководство по обслуживанию

Страница: 31 / 94

12 Removing the Compressor Inlet Filter
12.1 Remove the pressure control knob from the pump (Refer to Page 3, Section 2).
12.2 Remove the rear case assembly (Refer to Page 5, Section 6).
12.3 Carefully pull the filter retaining clip (Fig 6, Item 30) from the ‘F’ tube connector (Fig 6, Item 20).
12.4 Remove and discard the old inlet filter (Fig 6, Item 40).
13 Installing the Compressor Inlet Filter
13.1 Locate a new inlet filter (Fig 6, Item 40) over the air intake hole in the case of the compressor
assembly (Fig 6, Item 10).
13.2 Carefully reposition the filter retaining Clip (Fig 6, Item 30) on the ‘F’ tube connector (Fig 6,
Item 20) to retain the inlet filter (Fig 6, Item 40). Make sure the clip is fitted with the longer arm
downward if appropriate.
13.3 Assemble the rear case to the pump (Refer to Page 5, Section 7).
13.4 Install the pressure control knob from the pump (Refer to Page 3, Section 3).
Issue 2 Chap 3
Nov 2001 SER0004 Page 11
Mini Pump Service Manual Pump Repair