HunterLab MiniScan EZ, Дополнительное руководство

Страница: 9 / 29

MiniScan EZ Supplemental Manual for EasyMatch QC
9
MiniScan EZ Installation
The MiniScan EZ is simple to set up and attach to your computer. Before operating the MiniScan EZ
with EasyMatch QC, you need only install the batteries and connect the instrument to your computer.
These steps are outlined below.
1. Unpack the carrying case and remove wrappings and cable ties. Inspect for damage and
notify the carrier and HunterLab immediately if any is discovered. Save the packing
materials in case it becomes necessary to return the instrument to the factory.
2. Open the battery compartment on the bottom of the MiniScan EZ.
Figure 3. Battery Compartment of the MiniScan EZ
3. Install the 6 AA batteries, observing the positive (+) and negative (-) polarity guides inside
the battery compartment.
Figure 4. Install AA Batteries
Note: The MiniScan EZ can use six standard AA alkaline batteries or six rechargeable AA
NiMH batteries. Do not mix battery types in the instrument. To recharge the NiMH
batteries, remove them from the instrument and recharge them using the supplied charger.
4. Close the battery compartment.
5. Plug the hexagonal (Mini-A) end of the USB cable into the USB port on the MiniScan EZ.