HunterLab ColorFlex EZ Citrus, Руководство пользователя

Страница: 8 / 66

ColorFlex EZ Citrus Citrus User’s Manual Version 2.0
8
•
HunterLab Citrus standard. This standard is used to hitch the instrument and
improve inter-instrument agreement of processed Citrus products.
•
Standards care card - gives instructions on how to clean the standards.
•
USB Flash Drive for data transfer
•
AC adapter, 12 W/9V.
•
ColorFlex EZ Citrus User’s Manual on CD.
Installation
Before operating the ColorFlex EZ Citrus, connect the instrument to a power source, a
computer or to an optional component, such as a printer. Instructions are provided below.
1.
Unpack the cartons and remove wrappings and cable ties. Inspect for damage and
notify the carrier and HunterLab immediately if any is discovered. Save the packing
materials in case it becomes necessary to return the instrument to the factory.
2.
Place the ColorFlex EZ Citrus on a flat, stable surface near and electrical outlet.
3.
Set the instrument up on the sample clamp/port-forward stand, (attached to the
instrument at the factory). To use the sample clamp, pull the spring-loaded clamp
away from the sample port, insert the item to be measured (such as the black glass
or white instrument standard), and gently release the clamp.
4.
Remove the standard port insert from the sample port and replace it with the
orange juice tube holder port plate. Orient the port plate so that the opening in the
tube holder portion is facing upward. Insert the alignment pin on the tube holder
into the small alignment hole at the top of the instrument port. When the pin is
properly installed into the hole, the tube holder should be held firmly in the upright
position at the instrument port and should not be allowed to rotate.
5.
Connect the connector of the AC adapter to the acceptor on the left back of the
ColorFlex EZ Citrus.
6.
Plug the female end of the power cord into the AC Adapter and the male end into a
wall outlet.
7.
If the instrument is to be used connected to a computer, printer, or other USB
device, plug the hexagonal end of the USB cable into the USB port on the ColorFlex
EZ Citrus.
8.
Plug the flat end of the USB cable into the appropriate USB port on the computer or
device. If connecting to a computer, Windows’ plug and play feature should
automatically find and install the ColorFlex EZ Citrus. Let it do so until the FOUND
NEW HARDWARE message disappears. Other devices, such as the printer, bar code
reader, and keyboard, are automatically detected by the ColorFlex EZ Citrus.
9.
Turn the ColorFlex EZ Citrus on by pressing the GO (lightning bolt ) button on the
button pad.
CHAPTER TWO