Hunter Hydrawise HCC, Руководство пользователя

Страница: 30 / 55

Flow Meter - Installation Quick
Start Guide
In this Quick Start Guide, you will learn how to install and configure your flow meter. For
support of Hydrawise™ cloud software or help with your Hydrawise account, visit the
support section here
[9]
. For specification information, refer to the section here
[10]
.
The flow meter consists of two parts:
1. Flowmeter body: The flowmeter body contains an analog dial for manual readings as
follows. Your flow meter will have 3 wires protruding from the body. The wires need to be
connected to the sensor inputs on the controller for readings in the software application. In
all models, only 2 wires (blue and white) are used.
2. Adapter:
Each flow meter has an adapter to allow connection to your irrigation system.
3. Flowmeter location:
Flow meters are installed between the master valve and zone
valves. To avoid false alerts, there should be no water taps or other uncontrolled water use
on the downstream side of the flow meter. If all solenoids connected to the controller are
not grouped together, it may be necessary to install more than one flow meter. For proper
installation and optimal water flow, use the chart below when determining pipe length. The
pipe bringing water into the flow meter needs to be 10 times longer than the width of the
pipe. The pipe carrying water away from the meter needs to be 5 times the width of the
pipe.
Copyright 2020 Hunter Industries. All Rights Reserved. 30