#2 Chootoo Road, South Aranguez, San Juan, Trinidad
9
1886
1886
Installing the Glass
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
Position the notches in the outer rim of the globe
so they line up with the three tabs on the inside rim
of the housing. Carefully lift the globe up inside the
housing as far as it will go, then rotate the globe
clockwise until it is held tightly in place by the tabs.
Notch
Tab
Ceiling Bracket
Hanging Fan
Wiring
Canopy
Blades
Light
Glass
Remote
Troubleshooting
Downrod
ON
Turn P
ow
er
Using the Remote Control Cradle
Tunable White
Preparing the Remote Control
The remote control is already
paired for use.
To access the battery compartment, remove the small
Phillips head screw that secures the battery door to
the transmitter assembly. Install one 3-Volt, CR2032
battery, found in the remote control hardware bag, into
the transmitter. Clean the battery contacts and also
those of the device prior to battery installation. The
battery should be installed with the positive (+) side up.
Please contact your local battery recycling center for
proper battery disposal information.
NOTICE
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure the batteries are installed correctly with regard to polarity (+ and -).
• Remove batteries from equipment which is not to be used for an extended period of time.
• Remove used batteries promptly.
Battery Door
Battery
Screw
HUNTER - DEMPSEY - CEILING FAN
ACCESSORIES GUIDE
