Hunt Graphics IMAGE 410, Руководство пользователя

Страница: 24 / 29

- 24 -
3
H
ERROR CODES
The machine shuts down and the display starts blinking.
This means that the software has detected an error in the
system. The numbers on the displays tell you what error
has occurred. The speed display will show the error
level. The top temperature display will show the error
data. These displays are used to find the problem. (The
bottom temperature display shows the current running
program number.) The first time an error occurs on your
machine, reset your power by depressing and resetting
the Emergency stop button. If the error occurs again, see
the chart. The chart defines some of the problems that
may have caused the error. If you cannot define the
problem, contact your distributor or sales representative
for technical assistance.
Note : After an error has shut down the system, the
power must be turned off for 10 seconds, using the
Emergency stop button. After 10 seconds, turn the power
on to restore the system.
*
Warning! Authorized service technicians must
disconnect the power by using the power disconnect
before servicing.
Speed Display Top Temp Display Problem
Error Level 1.0 Error Data 1 The photo-eye has
failed.
Error Level 1.0 Error Data 5 The digital I/O (DIO)
card is defective.
Error Level 2.0 Error Data 0 Reset. If error
occurs again, the
digital I/O (DIO) card
is defective.
Error Level 2.1 Error Data 1 The Solid State
Relay for the top
main roll heater is
defective.
Error Level 2.1 Error Data 2 The Solid State
Relay for the bottom
main roll heater is
defective.
Error Level 2.1 Error Data 3 If the rollers are hot,
the Digital I/O (DIO)
card has failed. If
the rollers are cold,
The Analog Card has
failed.
Error Level 2.2 Error Data 1 The top
thermocouple is
defective or has a
bad connection.
Error Level 2.2 Error Data 2 The bottom
thermocouple is
defective or has a
bad connection.
Error Level 2.2 Error Data 3 The Analog I/O (AIO)
Card is defective.
Error Level 3.0 Error Data 0 The Nip Motor is
locked or the
encoder is defective.