Hunt Graphics IMAGE 410, Руководство пользователя

Страница: 21 / 29

- 21 -
3
H
APPLYING OVERLAMINATE TO IMAGES USING
PRE-COATED SUBSTRATE
This process involves applying an over laminate to an
image with the use of a sled or pre-coated substrate.
Preparation:
Set your nip in accordance with the thickness of the
board you will be using.
Load a roll of pressure sensitive laminating film on the
top unwind shaft.
Do not remove the release liner from the sled.
Webbing
n
Pull the film down from the top unwind. Separate the
film from the release liner and lay the film over the top
roller.
n
Connect the release liner to the windup tube with a
piece of tape. Attaching the release liner to a
cardboard core (over the windup tube) will allow for
easier cleanup.
n
Pull the film evenly across the face of the main rollers.
n
Feed a leader board that is the same thickness as the
sled, into the nip. Make sure that the film is adhered
to the release liner on the leader board.
n
Place an image face up on a sled and send it through
the nip.
n
When the sled comes through, place another leader
board between the nips to hold the film.
n
You may now cut the image away from the sled.
Sled
Pressure Sensitive Film
Media
Release Liner