Troubleshooting
Q: No LED display after powered on. (HTA-810/820/830)
A: Please make sure DC12V power adaptor is properly plugged with correct polarity.
Q: Unable to establish communications.
A: For HTA-810/820, please make sure the device ID is correctly set. For HTA-830/840,
make sure the IP port is correctly set.
Q: I swiped the card, but the device has no response.
A: 1. Please check if the card format matches model purchased.
2. Please make sure card registry process is complete.
3. Please swipe the card again at normal speed.
4. Please make sure the right side of card swiped.
Q: An Err or Bad code appears after swipe of cards.
A: Please refer to appendix, Error Message Code for more information. Contact the dealer
if “bad code” appears.
22
Содержание HTA-810
