7
532310-3_A
TRANSDUCER
Installation Guide
Maintenance
If your transducer remains in the water for long periods of
time,
slush, algae and other marine growth can reduce the
effectiveness of the transducer. Periodically clean the face
of the transducer with a mild, marine-safe and plastic-safe
soap or solution.
If your transducer remains out of the water for a long
period of time,
it may take some time to wet the transducer
after it is returned to the water. Small air bubbles can cling
to the surface of the transducer and interfere with proper
operation. These bubbles will dissipate with time, or you may
wipe the face of the transducer with your fingers after the
transducer is in the water.
Contact Humminbird
Web site:
humminbird.com
E-mail:
Telephone:
1-800-633-1468
Direct Shipping:
Humminbird
Service Department
678 Humminbird Lane
Eufaula, AL 36027 USA
WARNING!
Disassembly and repair of this electronic unit should
only be performed by authorized service personnel. Any modification
of the serial number or attempt to repair the original equipment or
accessories by unauthorized individuals will void the warranty.
WARNING!
The transducer must be fully submerged in water during
operation because the sonar signal cannot pass through air. Air
pinging can damage the transducer.
NOTE:
Download Humminbird installation guides and operations
manuals from our Web site at
humminbird.com
.
NOTE:
Product specifications and features are subject to change
without notice.
ENVIRONMENTAL COMPLIANCE STATEMENT:
It is the intention of Johnson
Outdoors Marine Electronics, Inc. to be a responsible corporate citizen,
operating in compliance with known and applicable environmental
regulations, and a good neighbor in the communities where we make or
sell our products.
WEEE DIRECTIVE:
EU Directive 2002/96/EC “Waste of Electrical and
Electronic Equipment Directive (WEEE)” impacts most distributors,
sellers, and manufacturers of consumer electronics in the European
Union. The WEEE Directive requires the producer of consumer electronics
to take responsibility for the management of waste from their products to
achieve environmentally responsible disposal during the product life cycle.
WEEE compliance may not be required in your location for electrical &
electronic equipment (EEE), nor may it be required for EEE designed and
intended as fixed or temporary installation in transportation vehicles such
as automobiles, aircraft, and boats. In some European Union member
states, these vehicles are considered outside of the scope of the Directive,
and EEE for those applications can be considered excluded from the WEEE
Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product
must not be disposed of with other household refuse. It must be
disposed of and collected for recycling and recovery of waste EEE.
Johnson Outdoors Marine Electronics, Inc. will mark all EEE
products in accordance with the WEEE Directive. It is our goal to comply in
the collection, treatment, recovery, and environmentally sound disposal
of those products; however, these requirements do vary within European
Union member states. For more information about where you should
dispose of your waste equipment for recycling and recovery and/or your
European Union member state requirements, please contact your dealer
or distributor from which your product was purchased.
© 2019 Johnson Outdoors Marine Electronics, Inc. All rights reserved.