human care 11000490, Руководство пользователя, Страница: 10 / 20

10
www.humancaregroup.com
Battery
Always ensure that battery is sufficiently charged
before using this lift. The battery will not charge if
the emergency stop is engaged.
The battery in this device is located in the module
along with the control box.
These batteries have a tamper proof seal that is
located on the battery to make it easier to see if
the battery has been tampered/replaced by a non-
authorized person. This seal should be replaced
after battery replacement.
Changing the Battery
Remove all external cables
from the control box. Remove
from frame.
On the back side of the
module, unscrew and remove
the 7 torx screws on the rear
of the control box/battery
module to open.
Disconnect the battery
connectors and remove the
old batteries.
Insert the new batteries in
the same direction as the old
batteries, with the connectors
at the top and connect (Note:
+= red, - = black). Be careful
not to bend the connectors.

Do not cover the holes.
 Ensure that none of the
wires are squeezed or caught
when reinstalling the cover.

Ensure the mains is not
connected.
Ensure that the silicone string
is in place and properly fitted
before reinstalling the cover.
Replace seal if necessary.
The silicone string separates the battery from the
electronics and must not be damaged or modified
as it will allow penetration of battery gas into the
electronics components with risk of explosion. Do
not use if this seal is damaged in any way.
Charging the Battery
The battery should be charged minimum 8 hours
before it is used for the first time.