Hughes HX100, Руководство по установке

Страница: 134 / 138

Appendix D • Conforming with standards and directives
116
1037106-0001 Revision B.03-Draft
Repairs in the United States If trouble is experienced with the Two-Way Hughes System
equipment, for repair or warranty information, contact your
service provider.
If the equipment is causing harm to the telephone network, the
Telephone Company may request that you disconnect the
equipment until the problem is resolved.
Hughes must make any necessary repairs to the modem portion of
this equipment in order to maintain valid FCC registration. Do
not attempt to repair or service your modem. Return it to Hughes.
No repairs can be made by customers. All repairs must be done
by Hughes Authorized Service Centers (ASCs). This equipment
cannot be used on public coin service provided by the Telephone
Company. Connection to Party Line Service is subject to state
tariffs. Contact the state public utility commission, public service
commission or corporate commission for information.
Canada – equipment
attachment limitations
The Industry Canada label identifies certified equipment. This
certification means that the equipment meets certain
telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal
Equipment Technical Requirement Documents. The Department
does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should make sure they are
permitted to connect to the facilities of the local
Telecommunications Company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The customer
should be aware that compliance with the above conditions might
not prevent degradation of service in some situations.
Note: This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is confirmed
by the registration number. The abbreviation IC before the
registration number signifies that registration was performed
based on a Declaration of Conformity indicating that Industry
Canada technical specifications were met. It does not imply that
Industry Canada approved the equipment.