Hughes HN9800, Руководство по установке, Страница: 18 / 66

Chapter 2 • Preparing for installation
18
1039707-0001 Revision A
Requirements for cables, connectors, and ground blocks
You must use approved cable types and connectors to connect the modem to the
outdoor satellite antenna. For grounding, you must use approved ground blocks and
grounding connectors. For detailed specifications and information on these
components, see the documents listed in Table 2 on page 19.
The coaxial IFL cable and the ground block to which they are connected must meet
the grounding requirements specified in the following warning:
You must comply with applicable local codes and the grounding requirements in
Field Service Bulletin (FSB),
HNS Broadband Requirements for RG-6 and RG-11
IFL Cable Connectors, Ground Blocks, and Ground Block Location
(FSB_050518_01). Improper grounding can result in electric shock injury,
property damage, and/or poor modem performance.
Labeling the IFL cable
Label the IFL cable at the outdoor point-of-entry and at the indoor location where
the satellite modem is installed as follows:
Wrap a piece of blue electrical tape around the cable, and mark SAT on the tape.
Hub or similar network device
The customer must supply and configure the network device, including required
cables, according to the device manufacturer's documentation. Required IP address
information is obtained during modem commissioning.
Instructions for related components
This installation guide covers only installation of the satellite modem. For installation
instructions for other components, see Table 2 on page 19.
WARNING