Hughes HN9500, Руководство по установке

Страница: 101 / 136

Range of values Typical values Parameter
Server
Relay
Server, Relay, or Disabled DHCP Mode
Disabled
Disabled
{IPv6 address range}
A list of DHCPv6 server IPv6
addresses DHCPv6 Mode
Not applicable Disabled IRDP Preference
Not applicable Disabled RIP Mode
Not applicable Disabled RIPng Mode
Not applicable Disabled ND Router Advertisement Mode
Not applicable Disabled ISRP Mode
Not applicable Disabled ISRP Redirect Behavior
Not applicable Enabled IGMP Receive
Not applicable Enabled IGMP Send Mode
Not applicable Disabled H.323 Proxy
Not applicable Disabled Dialer Proxy
Not applicable Enabled TCP Acceleration
Not applicable Enabled HTTP GET Compression
Not applicable Enabled DNS Caching
Not applicable Enabled Turbo Page
Not applicable Disabled SSL Acceleration
Not applicable Disabled DSCP Mode
Not applicable Disabled VRRP
Not applicable Disabled PBR
Not applicable Disabled IPsec
State codes
A state code is a number that indicates the operational state of the satellite router. Some state
codes indicate an error condition. State codes are identified as
State code followed by a number
from 1 – 35. They are displayed with an explanation in words, as shown in the following examples.
State codes appear on installation screens, on screens displayed during a hard reboot (when
power is removed and then restored), and on System Control Center pages.
87
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 9 System Control Center