Hubner FGH 8, Инструкция по эксплуатации и сборке

Страница: 19 / 30

Incremental hollow shaft encoder FGH 8
FGH8_MANUAL-en_R6(2018-11-19)ID74584.docx
19
8 Inspections
8.1 Safety instructions
Personnel
Skilled technical staff only are permitted to inspect the device and its installation.
Observe the safety instructions contained in Chapter 2 when inspecting or working on the
device.
8.2 Maintenance information
The device is maintenance-free. However, to guarantee optimum fault-free operations we recommend
that you carry out the following inspections.
8.3 Inspection schedule
Interval Inspections Tasks
All 12 month Check coupling Qualified person
All 12 month Check the fastening screws for firm
seat Qualified person
Check the cable connections Qualified person
After approx. 16000 to
20000 operating hours and
high long-term loading Check deep-groove ball bearing for
ease of movement and noise. Qualified person
Worn ball bearings have to be replaced
only by the Manufacturer Hubner – Giessen Service