Huber Unichiller 400T, Руководство по эксплуатации

Страница: 56 / 86

Setup mode
OPERATION MANUAL Chapter 4
Unichiller®
V2.3.0en/07.06.19//17.12
56
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Control Dynamics”.

Choose between the dialog entries “Fast, small overshoot” and “Without overshoot”.

Confirm your choice by tapping on “OK”.
4.2.8.3 Sub-category: “Fluid Properties”
4.2.8.3.1 Sub-category “Select Fluid”
Under this entry, you can select the thermal fluid used from a list.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Fluid Properties”.

Tap on the sub-category “Select Fluid”.

Select the thermal fluid used from the list.

Confirm your choice by tapping on “OK”.
4.2.8.3.2 Sub-category: “Bath/Circulation Volume”
Under this entry, you can enter the filling volume of the thermal fluid in your bath/circuit.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Fluid Properties”.

Tap on the sub-category “Bath/Circulation Volume”.

Read the message and confirm it by tapping on “OK”.

Enter the filling volume using the number keypad that appears.

Confirm your entry by tapping on “OK”.
4.2.8.3.3 Sub-category: “VPC/Bypass”
Under this entry, you can specify whether you use a bypass or not.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration auto”.

Tap on the sub-category “Fluid Properties”.

Tap on the sub-category “VPC/Bypass”.

Choose between the dialog entries “Bypass used” and “Bypass not used”.

Confirm your choice by tapping on “OK”.