Huber Pilot ONE Unichiller 00 eo Series, Руководство пользователя, Страница: 44 / 86

Setup mode
OPERATION MANUAL Chapter 4
Unichiller® eo Desktop
V2.2.0en/09.08.21//17.12
44
4 Setup mode
4.1 Setup mode
Moving the temperature control unit during operation
SERIOUS BURNS/FREEZING OF THE HOUSING PARTS/ESCAPING THERMAL FLUID

Do not move temperature control units that are in operation.
4.1.1 Turning on the temperature control unit
PROCEDURE

Turn on the temperature control unit using the >Mains switch< [37].
First, a system test is conducted to test the full functionality of the temperature control unit. All
sensors, the all-pole disconnecting power disconnect relay for the power supply and the power
electronics of the main heater and the main heater itself are checked. A message appears on the
>Touchscreen< [88] in case of an error or if a warning is issued. In case of doubt, please contact
Customer Support. → Page 84, section »Contact data« .
The following data entry is required only for:
a.) Initial start-up
b.) resetting the temperature control unit to the factory settings. → Page 41, section »Restore
factory settings« .

After switching on the temperature control unit, tap on the required system language.

Touch "OK" to confirm your selection.

Tap on the thermal fluid used.

Touch "OK" to confirm your selection.

Read the message and confirm by tapping on “OK”.

Enter the volume using the number keypad that appears.

Touch "OK" to confirm your entry.

Set the setpoint limits to the thermal fluid used. → Page 33, section »Information on the ther-
mal fluids« and → Page 57, section »Setting the setpoint thresholds« .
If your temperature control unit is not integrated into a network, confirm the preset IP address
(0.0.0.0) by tapping on “OK”. This skips the network settings.

Enter the required IP address using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Enter the required Subnet Mask using the number keypad that appears.

Confirm your entry by tapping on “OK”.

Tap on the required remote control mode.

Confirm your choice by tapping on “OK”.
4.1.2 Turning off the temperature control unit
PROCEDURE

Warm the thermofluid to room temperature.

Stop the thermoregulation.

Switch off the temperature control unit using the >Mains switch< [37].