Huber MPC Minichiller 280, Руководство пользователя

Страница: 22 / 60

Commissioning
OPERATION MANUAL Chapter 2
Minichiller®
V2.4.0en/09.08.21//1.30
22
2 Commissioning
2.1 In-plant transport
Temperature control unit is not transported / moved according to the specifications in this oper-
ation manual
DEATH OR SERIOUS INJURY DUE TO CRUSHING

Always transport / move the temperature control unit according to the specifications in this
operation manual.

Wear personal protective equipment during transport.

Always work with the specified number of persons when moving the temperature control unit
on casters (if any).

If the temperature control unit is equipped with casters and parking brakes: 2 parking brakes are always
freely accessible when moving the temperature control unit. Activate the 2 parking brakes in an emergen-
cy! If only one parking brake is activated on the casters in an emergency: The temperature control unit is
not stopped but rotates around the axis of the caster with the activated parking brake!
Temperature control unit transported in a horizontal position
DAMAGE TO THE COMPRESSOR

Only transport the temperature control unit in an upright position.
Filled temperature control unit is transported
MATERIAL DAMAGE DUE TO OVERFLOWING THERMAL FLUID

Only transport an emptied temperature control unit.
▪ If available, use the eyes on the top side of the temperature control unit for transportation.
▪ Use an industrial truck for transport.
▪ The casters on the temperature control unit are not suitable for transport. The casters are sym-
metrically loaded with 25% of the total mass of the temperature control unit.
▪ Remove the packing material (e.g. the palette) only at the place of installation.
▪ Protect the temperature control unit from transport damage.
▪ Do not transport the temperature control unit alone and without aids.
▪ Check the load bearing capacity of the transportation route and the place of installation.
▪ The parking brakes at the casters (if present) must be activated and/or the leveling feet (if pre-
sent) must be unscrewed/activated before the temperature control unit is put into operation.
→ Page 30, section »Unscrewing/activating the leveling feet (if any)« .
2.1.1 Lifting and transporting the temperature control unit
2.1.1.1 Temperature control unit with lifting eyes
The temperature control unit is raised at the lifting eyes without load handling attachments
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Always use load handling attachments when lifting and transporting the temperature control unit.

The lifting eyes are only designed for a load without inclination (0°).

The load handling attachment used must be adequately dimensioned. Take the dimensions and
weight of the temperature control unit into account.
Example: lifting eyes
(round, angular, and
recessed (left to right))