7
INSTALLATION INSTRUCTIONS
UTB2
INSTALLATION INSTRUCTIONS
Hubbell Lighting, Inc. Doc. No. 93097040
A subsidiary of Hubbell Incorporated Revision P0
701 Millennium Drive • Greenville, SC 29607 Page 7 Phone (864) 678-1000
Mounting Bracket
FIGURE 7B
SENSOR INSTALLATION
FIGURE 7C
SENSOR INSTALLATION
Mounting Bracket
OCCUPANCY SENSOR INSTALLATION (If Optioned):
NOTE: If a wireguard is supplied, the wire guard needs to be installed first (see Page 9, Fig. 7A) before installing sensor on the
bracket. Position the guard so the sensor bracket fits through the top two rings of the guard.
1.
Position the sensor box (without the tightening ring attached) on top of the bracket and place the threaded shaft through
the hole in the bracket. Fasten the tightening ring onto the threads until sensor box is secure. See Fig. 7B
2.
Screw the sensor lens onto the threaded shaft until secure. See Fig. 7C.
FIGURE 7A
WIRE GUARD ASSEMBLY
W/ OCCUPANCY SENSOR
OPTION SCL/SCD
SCL/SCD SENSOR BRKT & RING ASSY
MUST BE POSITIONED FOR
CLEARANCE BETWEEN WG-16 OPENINGS
OCCUPANCY SENSOR INSTALLATION (If Optioned):
NOTE: If a wireguard is supplied, the wire guard needs to be installed first (see Page 9, Fig. 7A) before installing sensor on the
bracket. Position the guard so the sensor bracket fits through the top two rings of the guard.
1. Position the sensor box (without the tightening ring attached) on top of the bracket and place the threaded shaft through
the hole in the bracket. Fasten the tightening ring onto the threads until sensor box is secure. See Fig. 7B
2. Screw the sensor lens onto the threaded shaft until secure. See Fig. 7C.
HIL_93097040_A_UTB2_INST_18
For additional information on UTB, please visit our website:
https://www.hubbell.com/hubbellindustriallighting/en
