Pub. 42004-467D
Camera Telephone Manual
Page 20 of 30
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-467D.docx
04/19
Table 3. Auto-Dialing Key Sequence Setup
Feature
Key
Sequence
Description
Default
HELP
Button
Auto-dial
Number 1
DD
... *1
Assigns a telephone number to the auto-dial memory 1.
DD…
represents the telephone number digits. Telephone
numbers can be up to 24 digits long.
A pause may be required in the telephone number to wait
for a secondary dial tone for access to an outside line.
The
*#
key combination represents a pause in the
telephone number.
Examples:
To assign the police emergency number
911
to the
auto-dial button, enter
911*1
.
To assign
911
when a
9
is required to gain access to a
CO line, enter
9*#911*1
.
To store
*
or
#
as part of the auto-dial number, (such as
for speed dialing), enter these digits twice in succession.
None
HELP
Button
Auto-dial
Number 2
DD
... *2
Same as
HELP
Button Auto-dial Number 1 except the
sequence ends in *2 instead of *1.
None
HELP
Button
Auto-dial
Number 3
DD
... *3
Same as
HELP
Button Auto-dial Number 1 except the
sequence ends in *3 instead of *1.
None
CALL
or
ASSISTANCE
Button Auto-
dial
DD
... *4
DD
... *5
DD
... *6
Same as HELP Button Auto-dial Number 1 except the
sequence end digits.
N
OTE
:
The *5 and *6 telephone numbers are used only
when operating in SMART mode.
None
Primary Dial
Tone Delay
# 1 0
N N
Dial tone delay is the amount of time the telephone waits
for a dial tone before auto-dialing the telephone number.
(00 [20 seconds] | 01–15 seconds)
Example
: Enter
# 1 0 0 5
to wait 5 seconds for a dial
tone.
03 (3seconds)
Secondary Dial
Tone Delay
# 1 1
N N
This feature is only used if a 9 must be dialed to access an
outside line. It determines the amount of time (00–15
seconds) that the telephone waits for a second dial tone.
In the example for the
A
UTO
-D
IAL
1
Number 1 feature
above, the 9*# digits prefix the auto-dial number to add
the pause. This programming parameter allows choosing
the amount of time the telephone waits after sending the 9
before dialing the auto-dial number.
Example
: Enter
# 1 1 1 0
to wait 10 seconds for the
second dial tone.
02 (2 seconds)
Ring-down
Operation
*1
This option clears the telephone number to prevent auto-
dialing when the button is pressed. The ring-down
system must detect the loop current and ring-down to the
appropriate telephone after the button is pressed.
None
