Pub. 42004-438M
300 Series Emergency Telephone Manual
Page 38 of 50
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-438M.docx
04/19
Auto-Answer Alert
When auto-answering an incoming call, the RED ALERT
®
telephone will generate a splash tone on the
telephone line. This tone is always heard by the calling party. This tone can be pre-programmed to also
be heard over the telephone’s integral speaker using this key sequence.
Table 6. Auto-Answer Alert Configuration
Feature
Key
Sequence
Description
Default
Auto-answer
Alert
# 1 6
L
The auto-answer alert feature allows a person to call the
emergency telephone and monitor the area around the
telephone with or without sounding a splash tone over the
unit’s integral speaker.
(Disable alert tone),
L
=0.
(Enable alert tone),
L
=
1
.
1 (Enabled)
Off-Hook Ringing
The emergency telephone can generate a ringing signal from the speaker when the telephone is called.
The factory default setting for this feature is
disabled
.
N
OTE
:
In addition to enabling this feature, the auto-answer feature must also be enabled for proper
operation.
Table 7. Off-Hook Ringing
Feature
Key
Sequence
Description
Default
Off-Hook
Ringing
# 2 2
L
Enabling the Off-Hook Ringing feature allows a person
to call the telephone and have the telephone function as a
normal telephone. The telephone will ring after the
splash tone is heard in the receiver if remote
programming is not commenced within 7 seconds of the
splash tone.
To enable the ringing feature (enable splash tone and
ringing),
L
=1. To disable the ringing feature (only splash
tone on the phone),
L
=0.
N
OTE
:
Only RED ALERT
®
Telephones equipped with a
CALL
push button can be answered when they are
ringing by pressing the push button.
0 (Disabled)
