IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Battery Backup Exit and Unit Combo
CLSC
WARNING
: RISK OF ELECTRIC SHOCK – NEVER CONN
EQUIPMENT IS ENERGIZED.
NECT TO, DISCONNECT FROM, OR SERVICE WHILE
Warning:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH,
SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these
warnings and instructions carefully before installing or maintaining this equipment. These instructions
do not attempt to cover all installation and maintenance situations
Warning:
RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe
lamp manufacturer’s warnings, recommendations and restrictions on lamp operation and maintenance.
Make sure lamps are correctly installed.
•
All service shall be performed by qualified service personnel. This product must be installed and
maintained in accordance with the applicable installation codes by a person familiar with the construction
operation of the product and the hazards involved.
•
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect A.C. power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
May be used outdoors under cover (20°C - 50°C)
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Equipment should be mounted in locations at heights where it will not readily be subjected to tampering by
unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause and unsafe condition.
•
Do not use this equipment for other than intended use.
•
The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any
other voltage.
