HUAYUAN SLG-200HF, Инструкция по эксплуатации, Страница: 23 / 53

16
○
B Arc initiator QFK-E1
○
C Torch HYC-400B

Cables and connecting pipes
：
○
1 Grid power input cable
○
2 Arc voltage output cable
（
Connect with the automatic control equipment which require arc voltage signal
）
○
3 CNC control signal connect cable
○
4 Robot control signal connect cable
○
5 RS485 Communication connect cable
○
6
～
○
13 Integrated cable
（
From power source to arc initiator
）
○
6
Plasma arc initiator solenoid valve control cable
○
7 Plasma arc initiator power cable
○
8 Plasma gas hose
○
9
Shield gas hose
○
10 Pilot arc cable
○
11 Negative cable
○
12
Coolant return pipe
○
13 Coolant supply pipe
○
14 Work cable
（
earth cable
）
○
15 Torch cable
○
16 Shield gas input hose
○
17
Shield gas input hose
（
N
2
/Air
）
○
18 Plasma gas input hose
（
O
2
）
7. Installation of plasma cutting power source
（
Part A
）
1)
Plasma source positioning

When carry by forklift, the forked plate must long enough to hold the whole machine, lightly up and down,
slowly move;

Put the machine in a dry and clean place. If install the machine on beam of a machine tool, do fix it well in
case of dropping. No covering on the whole machine for ventilating and repairing;

Do not install any filter device on air inlet, or the cooling efficiency will be affected;

Don’t put the plasma source on the tilting space more than 10°