Huawei ViewPoint 8650 V100R008, Быстрый старт

Страница: 29 / 36

ViewPoint 8650
Quick Start Guide
4 Holding a Conference on the Web Interface
Issue 04 (2013-07-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
26
Parameter Description Setting
participant that added to
the cascaded conference as
a site in a cascaded
network
NOTE
It is unavailable for conferences
on the built-in web interface.
 Lower-level MCU :
participant that added to
the cascaded conference as
a site in a cascaded
network
NOTE
It is unavailable for conferences
on the built-in web interface.
Protocol type
Protocol used by a participant
endpoint. Available values are
H.323 and SIP .
Select H.323 .
Participant Number Participant number for the
endpoint. After the endpoint
registers with a GK, this
number can be used to call the
endpoint.
NOTE
If a GK is enabled for a conference,
enter the value of E.164, which is
predefined when
4.2.1 Setting GK
Registration Parameters on a
Videoconferencing Endpoint
.
Example: 0100001
Participant
Password Password used for the
authentication performed
when a participant endpoint
registers with a GK. This
password must be the same as
the password defined on the
participant endpoint. Set this parameter to the value of
Password described in 4.2.1
Setting GK Registration
Parameters on a
Videoconferencing Endpoint
.
Example: 123456
IP address The IP address of an endpoint
to be added. Example: 200.54.10.137
Quality It specifies the audio-visual
parameters and transmission
rate of the conference. The
higher the level, the better the
audio-visual experience.
NOTE
Make sure that the endpoints
support the audio-visual
protocol, format and participant
rate when
Quality is set to
Custom those parameters are
available to be set.
Default value: High
Step 5
Click OK .