Huawei USG9500 Series, Руководство по оборудованию

Страница: 459 / 514

Figure A-34 Sliding the heat-shrink tubing onto the bare crimping terminal
Step 3
Fix the OT terminal (B) onto the exposed conductor, ensuring that the OT terminal is in
sufficient contact with the insulation layer of the power cable (C), as shown in
Figure A-34 .
NOTICE
After the conductor is fed into the OT terminal, the protruding section of conductor (or L2 in
Figure A-34 ) must not exceed 2 mm.
Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure
A-35 .
NOTE
The shapes of crimped parts may vary with the crimping dies.
Figure A-35 Crimping the joint parts of the bare crimping terminal and the conductor
Step 5 Slide the heat-shrink tubing (A) towards the connector until the tube covers the crimped part
and then heat the tube with a heat gun, as shown in
Figure A-36 .
HUAWEI USG9500 Series
Hardware Guide
A Appendix
Issue 03 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
447