Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1
Run the
system-view
command to enter the system view.
Step 2
Run the
bgp
as-number
command to enable BGP and enter the BGP view.
By default, BGP is disabled.
Step 3
Run the
ipv4-family
vpn-instance
vpn-instance-name
command to enter the BGP-VPN
instance view.
Step 4
Run the
peer
ipv4-address
as-number
as-number
command to configure the PE as the peer of
a VPN private network.
Step 5
(Optional) Run the
import-route
protocol
[
process-id
] [
med
med
|
route-policy
route-policy-
name
]
*
command to import routes from other routing protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
----End
11.5.7 Checking the Configuration
Run the
display ip routing-table vpn-instance
on the PE, and you can find the routes to the
local VPN.
11.6 MCE Configuration Examples
This section provides several configuration examples of MCE.
11.6.1 Example for Configuring MCE
Networking Requirements
, the networking is as follows:
l
CE1, CE2, CE3, and CE4 are edge devices of the VPN.
l
CE1 and CE3 belong to a VPN instance named
vpnb
, and CE2 and CE4 belong to a VPN
instance named
vpna
.
l
PE1 and PE2 are edge routers of the backbone network.BGP or MPLS IP VPN is configured
on the backbone network between PE1 and PE2.
l
The MCE functions as a Multi-VPN-Instance CE located in the user network.
l
OSPF is run between the MCE and PE2.
It is required that route isolation between VPNs be implemented on the MCE and routes of VPNs
be advertised to the PE2 through OSPF.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
11 MCE Configuration
Issue 01 (2012-03-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
640
