l
To perform the NQA test after a certain delay period, run the
start
delay
{
seconds
second
|
hh
:
mm
:
ss
} [
end
{
at
[
yyyy
/
mm
/
dd
]
hh
:
mm
:
ss
|
delay
{
seconds
second
|
hh
:
mm
:
ss
} |
lifetime
{
seconds
second
|
hh
:
mm
:
ss
} } ] command.
The test instance is started after a certain delay.
The differences between the TCP Public tests and the TCP Private tests are as follows:
l
The TCP Public tests do not require the destination port to be configured on the client.
Connection requests are initiated and sent to the TCP port 7 of the destination address. The
server should monitor the TCP port 7.
l
The TCP Private tests require the destination port be specified and the related monitoring
services enabled on the server.
----End
6.12.4 Checking the Configuration
After configuring the TCP test, you can view the test result.
Prerequisite
The configurations of the TCP Test function are complete.
Context
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the
display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Procedure
l
Run the
display nqa results
[
test-instance
admin-name
test-name
] command to view the
test results on the NQA client.
l
Run the
display nqa-server
command to view the information about the NQA server.
----End
Example
Run the
display nqa results
command. If the test is successful, the following is displayed.
<Quidway>
display nqa results
NQA entry(admin, tcp) :testflag is inactive ,testtype is tcp
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:0 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 31/62/51
Sum/Square-Sum Completion Time: 155/8649
Last Good Probe Time: 2006-8-5 15:55:15.3
Lost packet ratio: 0 %
Run the
display nqa-server
command,the status of the NQA server is displayed.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-33
