Step 4
After the parameter setting is complete, click
Confirm
and then click
Submit
. A system message
is displayed, indicating whether the parameter setting is successful.
----End
5.2 Setting ePico Cell Parameters
This chapter describes how to set or modify the ePico cell parameters manually. This mainly
introduces common configuration methods of the ePico cell parameters, including modifying
the cell status, modifying the cell frequency and scramble code, and setting the maximum TX
power.
Prerequisite
l
The parameters of the ePico zone have been set successfully.
l
You have logged in to the AP Manager (APM). The login account belongs to the
Administrator or Operators group.
Procedure
Step 1
Log in to the APM. Choose
Configuration
>
Single Configuration
and select an ePico3801 to
be maintained. Then, click
Configure
to enter the configuration window.
Step 2
Choose
Terminal Parameter
>
WIRELESS
>
Configuration
in the navigation tree to
configure the automatic pilot adjustment parameters.
1.
Choose
CELLSTATE
to modify the cell active status. Before activating the data of a cell,
you need to ensure that the data of the cell is complete and valid.
2.
Choose
CELLBASIC
to modify the basic information of the cell.
CAUTION
You can use this command to modify the AP frequency, scramble code, and neighboring
cell configuration mode after deactivating the cell. If the cell is in activated state, you cannot
modify the cell information directly.
3.
Choose
CELL
to modify the basic information of the cell. You can use this command to
modify the basic information such as the maximum TX power of a cell, PSCH TX power,
SSCH TX power, PCPICHP TX power, BCH TX power, and downlink maximum TX
power of UEs in a cell.
4.
Choose
CELLRESETUPTIMER
to set the timer for cell reestablishment. This command
is applicable to the automatic network planning mode. Before the timer for periodical cell
reestablishment expires, the cell performs network planning automatically again. In this
case, the ePico3801 automatically selects better parameters related to the network planning
to reestablish the cell according to the new radio environment so that the network quality
of the cell is optimized. If there are UEs in the cell when cell reestablishment time arrives,
the ePico3801 skips this cell reestablishment time and then reestablishes the cell when the
next cell reestablishment time arrives.
5.
Choose
MAXUEPOWERPARA
to set the maximum allowed uplink TX power of a UE.
ePico3801
User Guide
5 Reconfiguring the ePico3801
Issue 01 (2009–09–23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-3
