Procedure
Step 1
Run the
display nqa results
[
test-instance
admin-name
test-name
] command to view the test
results on the NQA client.
----End
Example
Run the
display nqa results
command. If the statistics about each hop are displayed, it means
that the traceroute test is successful.
<Quidway>
display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is trace
1 . Test 1 result The test is finished
Completion:success Attempts number:1
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
6.11 Configuring the SNMP Query Test
This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
6.11.1 Establishing the Configuration Task
Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l
Configuring the SNMP agent
l
Configuring routes between the NQA client and the SNMP agent
Data Preparation
To configure the SNMP query test, you need the following data.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
6 NQA Configuration
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
276