HTP MicroCut 45 DV, Руководство оператора

Страница: 15 / 23

10
4.3
Cutting Preparation
1.
Tightly connect the power cable to electrical socket outlet (the input voltage,
refer to the section 2. technology parameters)
2.
Connect the air line to the air supply equipment, and the ground cable to the
workpiece.
3.
Turn on the power switch. The power source light will be green when turned on.
4.
Regulate the current after the fan stops.
4.4
Cutting Operation
Note
：
1. If alarm light is on when cutting, you will need to let go of the trigger on the torch
until the alarm releases. Then press on the trigger to start cutting again.
2. In the automatic air test the machine will read the target air pressure in idle. To adjust
air pressure, press and realease the trigger so air stats flowing. Open the side door of
cabinate to adjust the air presure.
3. After using the machine for a longer period of time, the surface of the electrode and
nozzle will have an Oxidation reaction. Please make sure to replace the electrode and
nozzle. The alarm light will go on and the machine will stop working when it is time to
install a new shield cup.
Pull trigger
Turn on
the power
source
Air flows for 5 seconds,
check display to verify
pressure. Make
adjustments as needed
Pilot arc
ignites
the cutting arc
changes into
pilot arc again
Attach ground
clamp to
workpiece
shift to the workpiece,
the pilot arc changes
into the cutting arc
the torch
leaves the
workpiece,
Arc
extinguishes
grid/gouging /marking
Release Trigger Post-air
flow
normal