READ THROUGH ENTIRE INSTALLATION
INSTRUCTIONS BEFORE PROCEEDING
1. Position and mount with tape the enclosed Main Frame Mounting
Template to the rear of Table Saw, as shown in Figure 1. Set the Base
Line (on the template) 3 1/2" below the table top surface of the table saw.
Important: Base Line must be parallel with the table top or Outfeed
Roller unit will not work properly.
2. Using a center punch, mark the four (4) mounting holes on the Template.
Drill 1/8" pilot holes to reduce bit wander in sheet metal. Then enlarge
holes by drilling with 11/32" drill to accommodate 5/16" mounting bolts.
Step drills work especially good in sheet metal.
3. Mount the Main Frame
A
to the saw cabinet using two (2) stud pads
B
,
along with (2) 5/16"-18 x 1" bolts
D
, (2) 5/16" - 18 nuts
J
, (4) 5/16" flat
washers
H
and (4) 5/16" lock washers
I
. (Hand tighten only.)
Tip: When installing the stud pads and Main Frame on some machine
models, you’ll need to “hang” the stud through one of the holes, then
rotate the stud pad into position and thread the bolt into place. Usually
the back of the saw cabinet can be reached from the opening on the side
of the saw. On the rare occasions it’s necessary to lay the saw on its
side and feed them in from the bottom. Figure 2.
4. Assemble the Lower Main Frame Bracket to the Main Frame. Mount as
low as is practically possible, for best results. It can be flipped over if
needed. The point is to avoid any interferences on the cabinet.
Important: Do Not Drill the lower holes in the cabinet at this time.
5. Attach the Cams
N
to the Main Frame using Cam Bolts
P
and Knobs
O
as shown in Figures 3 & 4.
6. Install (1) one of the Pivot Bolts
Q
into one of the Cams, as shown in
Figures 4 & 5. Then slip the Roller Frame onto this Pivot Bolt. Swing the
Frame into position between the Cams and thread the other Pivot Bolt
into place. Refer to photos to get the correct orientation.
7. Attach the Adjustment Plate
L
to the underside of the Roller Frame as
shown in Figure 11 using (4) four 5/16" Carriage Bolts
M
, washers, lock
washers and nuts. Use care to orient the Adjustment Bolt to the ‘front’ as
shown.
8. Pivot Roller Frame out of your way. It can flip over onto the top of the
saw. Attach the Support Arm Assembly
K
, as shown in Figure 6, to the
bottom of the Main Frame with a Pivot Rod
G
and (2) two Acorn Nuts.
Note: It is very important to mount the correct end of the Support Arm
Assembly.
Roller
Roller
Frame
Cam
Cam
Main
Frame
Main
Frame
Front
View
Side
View
Lock
Knob
Lock
Knob
Cam
Bolt
Cam
Bolt
Pivot
Pin
Pivot
Pin
Figure 4
9
Figure 2
Figure 3
Figure 5
Figure 6