©HSS Hire Service Group Plc 2020 No. 703/01
76 Talbot Road, Old Trafford, Manchester, M16 0PQ
http://www.hss.com
...any comments?
If you have any suggestions to enable us to
improve the information within this guide
please email your comments to
Once
the connector has been
crimped and the motor cut
out
the jaws
will open,
remove the unit from the pipe
and proceed to the next connector.
If there is any danger to personnel during the pressing
process, press the emergency stop button and release
the ON switch.
Never push the equipment beyond its design
limits.
If it will not do what you want with reasonable
ease
and speed, assume you have the wrong tool for the
job.
Contact your local HSS Hire Shop for advice.
Keep the
equipment clean
- you will find this less of a
chore if you
clean it regularly, rather than wait until the
end of the hire
period.
When not in use
, store the equipment somewhere clean,
dry and safe
from thieves.
Disconnect the battery and place with the charger in the
carry case.
Remove the fitted jaw and place the de-burrer, jaw and
unit in the carry case ready for return,
to your
local HSS
Hire Shop.
FINISHING OFF
EQUIPMENT CARE
Crimping
Open
Fitting
Pipe
Closed
Each pipe connector has a pair of raised ridges which
locate within a recess in the crimping jaws.
One ridge for
each side of the connector.
Prepare the pipe by removing burrs and reaming the
edge
with the tool provided.
Place the connector onto the
pipe and place the jaws over the ridge on
the pipe side of
the connector.
Holding everything in position,
press the ON button to
activate the unit.
