843/01 Page 1 Black
PMS Pro. Blue
Heavy-Duty
Wet Vacuum
Cleaner
Hire Shops
A powerful industrial vacuum cleaner
for dedicated wet pick-up. Ideal for
liquid spillages and flooded areas.
Operating & Safety Guide 843
Next
fit the 3 wand sections together followed by
the vacuum head.
To switch the vacuum ON
simply
move the ON/OFF
switch to the ‘I’ position
. To
switch OFF move the switch to the
‘0’ position.
Familiarise yourself with the switch
and its location so that you can
operate it quickly in an emergency.
All that remains is to
plug the Vacuum into its power
supply and switch the supply ON.
Always
position yourself so you can control the
vacuums whereabouts
while ensuring that neither the
hose or the power supply cable are under strain.
Move the wand backward in straight strips
across
the floor, working in a methodical pattern to ensure the
entire area is vacuumed.
The first section of the wand has a black plastic
collar which will allow you to reduce the vacuum
power
to 70 percent, simply turn to show an opening in
the tube.
This first section also enables you to change the
height of the wand assembly
depending on which
way round it is set.
When the waste tank is filled to its maximum
capacity,
the ball float will block the vacuum and
the
motor will race
but there will be a loss of suction.
When this happens, turn the vacuum OFF,
then
disconnect the vacuum from its power supply.
Un-clip the discharge hose
from
the rear of the waste tank and
push
the rubber ball seal off of the
hoses
end. Empty the contents
via
the discharge hose
into a suitable
container
or down a suitable drain
if the liquid is safe to do so.
Once empty, push the rubber
ball seal back
over the discharge
hoses end,
failure to refit the ball will render the
vacuum unusable
. Clip the hose back onto the rear of
the waste tank.
Take your time and don’t overdo it.
You are more
likely to have an accident if you are tired or rushing.
Never push the equipment beyond its design
limits.
If it will not do what you want with reasonable
ease and speed, assume you either have the wrong type
EQUIPMENT CARE
BASIC TECHNIQUES
or size of model for the job. Contact your local HSS Hire
Shop for advice.
Keep the equipment clean,
you will find this less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Remember,
it is your responsibility to dispose of the
contents of the waste tank in a responsible
manner.
Handle the equipment with care
. Avoid dropping it,
knocking it, or otherwise exposing it to damage.
When not in use
, store the equipment somewhere
clean, dry and safe
from thieves. Protect this machine
from frost and freezing temperatures.
Switch OFF and unplug the vacuum.
Disconnect the head, wand and hose then empty
the waste tank.
Collect all the parts together, neatly coil the flex
and give the tool a final clean up ready for return
,
to your local HSS Hire Shop.
FINISHING OFF
Code 58221
©HSS Hire Service Group Plc 1998 No. 843/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk
Contact your local
0990 282828
…any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 0181-687 5001
ON
OFF
Discharge
Hose
Ball
